Are you an LLM? Read llms.txt for a summary of the docs, or llms-full.txt for the full context.
Skip to content

Bridge stablecoins to Radius

Transfer USDC or SBC from Ethereum or Base to Radius Network
View as Markdown

Overview

Radius supports bridging USDC and SBC from Ethereum and Base.

If you bridge USDC, it is converted to SBC on Radius.

Before you begin

Make sure you have:

  • A wallet with USDC or SBC on a supported source network
  • ETH (or Base ETH) for source-network gas fees

Open the dashboard

Go to:

Bridge steps

1. Connect your wallet

Connect your embedded or external wallet in the dashboard.

2. Select source and destination networks

For mainnet:

  • Source: Ethereum or Base
  • Destination: Radius Network
  • Token: USDC or SBC

For testnet:

  • Source: Sepolia or Base Sepolia
  • Destination: Radius Network Testnet
  • Token: SBC

3. Enter bridge amount

Enter the amount to bridge.

If you bridge USDC, it arrives as SBC on Radius.

4. Confirm and approve

Approve the transaction in your wallet on the source network.

Typical bridge times:

  • Ethereum: ~5–10 minutes
  • Base: ~1–2 minutes
  • Sepolia: ~5–10 minutes
  • Base Sepolia: ~1–2 minutes

5. Verify on Radius explorer

Check your balance and transfer status on the explorer:

Troubleshooting

If funds do not appear after the expected time:

  1. Confirm the source transaction is finalized.
  2. Verify you selected the correct destination network.
  3. Refresh the explorer and wallet balance view.
  4. Recheck the destination wallet address used in the bridge flow.

Next steps